Xerox Phaser 6180 - Out of Memory

Phaser 6180 Color Laser Printer Service Manual 3-71
Error Messages and Codes
Out of Memory
The printer memory is full and cannot continue to print. Print job requires
additional memory.
Applicable Chain Link
■ Chain Link 016-718: Out of memory
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Image Processor Board, PL9.1.27
■ Memory Card (Option), PL9.1.30
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 1. Check the required memory for the
print job.
2. Print a small size file (example as a
Windows test print).
3. Does the error still occur?
Go to step 2. Add memory
card or separate
the print job.
2 Reseat the memory card. Does the
error still occur?
Go to step 3. Complete.
3 Check the memory card capacity. Print
the printer Configuration Page: Menu
> Information Pgs > Configuration.
Does the memory meet the print job
requirements?
Replace the
Image
Processor Board
(page 8-89).
Go to step 4.
4 Replace the memory card. Does the
error still occur?
Replace the
Image
Processor Board
(page 8-89).
Complete.