Phaser 6180 Color Laser Printer Service Manual 6-5
Adjustments and Calibrations
Resetting the Fuser
Fuser reset is required when a new Fuser is installed into the printer. This
function sets the life counter to “0.”
1. From the Control Panel, press the Menu button.
2. Press the Up Arrow or Down Arrow button to find Admin Menu. Press
the OK button.
3. Press the Up Arrow or Down Arrow button to find Maintenance Mode.
Press the OK button.
4. Press the Up Arrow or Down Arrow button to find Reset Fuser. Press
the OK button.
5. “Are you sure?” message is displayed. Press the OK button to start the
process.
6. Initializing... --> Initialized messages are displayed. The Maintenance
Mode - Reset Fuser menu is displayed when the process is completed.
To Next Page
Loading...
