Xerox Phaser 6180 - Replace Fuser

3-34 Phaser 6180 Color Laser Printer Service Manual
Error Messages and Codes
Replace Fuser
The Fuser has reached its end of life.
W
arn
i
ng
The Fuser may be hot. Turn the printer power Off and allow at least 5
minutes for the Fuser to cool before removing the Fuser.
Applicable Chain Link
■ Chain Link 010-351: Replace Fuser
Initial Action
■ Check the Fuser life using CentreWare IS.
■ Cycle printer power.
■ If problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ Fuser, PL6.1.10
■ MCU Board, PL9.1.20
■ “Map 1 - Electrical and Drive” on
page 10-10
■ “Map 4 - LVPS and MCU Board” on
page 10-13
■ “Fuser” on page 10-46
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Check the Fuser life using CentreWare IS.
Does the Level show 0%?
Replace the
Fuser
(page 8-10).
Go to step 2.
2 Is the Fuser correctly installed? Go to step 3. Reseat the
Fuser.
3 Does the error still occur? Go to step 4. Complete.
4 Replace the Fuser (page 8-10). Does the
error still occur?
Replace the
MCU Board
(page 8-87).
Complete.