Xerox Phaser 6180 - Configuration, Memory, and Firmware Errors; Control Panel Language Set Unsupported

Phaser 6180 Color Laser Printer Service Manual 3-69
Error Messages and Codes
Configuration, Memory, and Firmware Errors
Control Panel Language Set Unsupported
The Control Panel does not support the language.
Applicable Chain Link
■ Chain Link 016-610: Control Panel Language Set unsupported
Initial Actions
■ Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts Wiring and Plug/Jack Map References
■ MCU Board, PL9.1.20
Troubleshooting Procedure Table
Step Actions and Questions Yes No
1 Turn the printer power Off and back
On. Does the error still occur?
Replace the
MCU Boar
(page 8-87).
Complete.