Xerox Phaser 6180 - Page 217

Phaser 6180 Color Laser Printer Service Manual 3-91
Error Messages and Codes
6 Check the Right Side Harness for
continuity.
1. Disconnect P/J25 and P/J251.
2. Check continuity between P/J25 <=>
P/J251.
Go to step 7. Replace the
Right Side
Harness.
7 Check the Drive Assembly signal.
1. Disconnect P/J25 from the MCU
Board.
2. Are there +24 V across ground <=>
J25-1/J25-2 when the Interlock
Switch is activated?
Replace the
Drive Assembly
(page 8-76).
Replace the
MCU Board
(page 8-87).
Troubleshooting Procedure Table (continued)
Step Actions and Questions Yes No