Xerox Phaser 6180 - Page 256

4-22 Phaser 6180 Color Laser Printer Service Manual
General Troubleshooting
Clear All NVM Clear All NVM
■ OK?
■ Processing
■ Initialized
<Press the Cancel button
to move one level up the
menu>
<Press the Set button to
run the test>
Clears all NVRAM of the Controller
including billing.
Clear Job
History
Clear JobHistory
■ OK?
■ Processing
■ Initialized
<Press the Cancel button
to move one level up the
menu>
<Press the Set button to
run the test>
Deletes the job history data.
Note: Job History can also be
initialized by Clear All NVM.
Clear
Auditron PV
Clear AuditronPV
■ OK?
■ Processing
■ Initialized
<Press the Cancel button
to move one level up the
menu>
<Press the Set button to
run the test>
Initializes Auditron or Print Volume.
Print Volume and Auditron work
exclusively and share the setting
memory area.
When Auditron is enabled, user
account and restricted information is
cleared.
When Print Volume is enabled, Print
Volume Counter is initialized.
Note: AuditronPV can also be initialized
by Clear All NVM.
Test Print Provides various test prints to be used for troubleshooting the
printer.
Menu Buttons
<Press the Up or Down
button to switch from
one item to another>
<Press the Cancel button
to move one/two level(s)
up the menu>
<Press the Set button to
run the test>
No Image IOT No Image IOT
■ Ready
■ Processing
Prints a blank page.
Test Pat600 IOT TestPat600 IOT
■ Ready
■ Processing
Prints the printer built-in Test Pattern
600 DPI. This test checks the print
function of the printer.
Grid 2 ESS Grid 2 ESS
■ Ready
■ Processing
Prints the Controller built-in grid
pattern. This test checks the print
function of the printer.
Service Diagnostic Test Table (continued)
Test Control Panel Display Test Description