Xerox Phaser 6180 - Page 544

10-4 Phaser 6180 Color Laser Printer Service Manual
Plug/Jack and Wiring Diagrams
J211 1 H-107 Connects Main Drive (Main Motor) and Right Side
Harness.
J220 1 F-106 Connects Control Panel and Control Panel Harness.
J221 1 H-108 Connects Main Drive (Sub Motor) and Right Side
Harness.
J222 1 G109 Connects Main Drive (Developer Motor) and Right
Side Harness.
J231 2 I-125 Connects Size Switch and Right Side Harness.
J232 2 H-125 Connects Feeder Unit (Registration Sensor Harness)
and Right Side Harness.
J233 2 H-123 Connects Registration Clutch and Right Side
Harness.
J234 2 I-124 Connects Feeder (Turn Clutch) and Right Side
Harness.
J235 2 H-123 Connects Feed Clutch with Right Side Harness.
J236 1 H-111 Connects Tray 1 (MPT) Feed Solenoid with Right
Side Harness.
J241 2 I-125 Connects OHP Sensor Harness with OHP Harness
(not used on 6180).
J251 1 H-110 Connects Drive Assembly (Tray 2 Motor) with Right
Side Harness.
J261 4 H-152 Connects Humidity/Temperature Sensor and
Humidity/Temperature Harness.
J272 1 I-110 Connects Front Cover Harness and Right Side
Harness.
J273 2 H-126 Connects Right Side Harness and Optional-550
Sheet Feeder (Feeder Unit Harness).
J275 1 I-108 Connects Tray 1 (MPT) No Paper Harness and Right
Side Harness.
J276 1 I-109 Connects Exit Clutch Harness and Right Side
Harness.
J311 2 G-124 Connects CRUM Sensor (Y) and CRUM Harness.
J312 2 G-123 Connects CRUM Sensor (M) and CRUM Harness.
J313 2 G-122 Connects CRUM Sensor (C) and CRUM Harness.
J314 2 G-122 Connects CRUM Sensor (K) and CRUM Harness.
J401 3 F-138 Connects Image Processor Board and Top Low
Voltage Harness.
J481 4 E-154 Connects Power Switch and Inlet Harness.
J501 4 F-149 Connects LVPS and Top Low Voltage Harness.
J502 4 F-149 Connects LVPS and Top Low Voltage Harness.
J503 4 F-149 Connects LVPS and Top Low Voltage Harness.
J504 4 F-149 Connects LVPS and Relay Test Harness.
Print Engine Plug/Jack Designators (continued)
P/J Map Coordinates
Remarks