"OK", "Alarm") of each LED can also be read under a common monitored data view for
programmable LEDs.
The LED status also provides a means for resetting the individual LED via
communication. The LED can also be reset from configuration with the RESET input.
The resetting and clearing function for all LEDs is under the Clear menu.
The menu structure for the programmable LEDs is presented in
Figure 13. The common
color selection setting Alarm colour for all ALARM inputs is in the General menu, while
the LED-specific settings are under the LED-specific menu nodes.
Alarm mode
Description
LED 1
Programmable LEDs
Alarm color Red
Green
Follow-S
Follow-F
Latched-S
LatchedAck-F-S
Programmable LED description
LED 2
General
GUID-0DED5640-4F67-4112-9A54-E8CAADFFE547 V1 EN
Figure 13: Menu structure
Alarm mode alternatives
The ALARM input behavior can be selected with the alarm mode settings from the
alternatives "Follow-S", "Follow-F", "Latched-S" and "LatchedAck-F-S". The OK input
behavior is always according to "Follow-S". The alarm input latched modes can be cleared
with the reset input in the application logic.
GUID-58B6C3F2-873A-4B13-9834-9BB21FCA5704 V1 EN
Figure 14: Symbols used in the sequence diagrams
"Follow-S": Follow Signal, ON
In this mode ALARM follows the input signal value, Non-latched.
1MAC059074-MB A Section 3
Basic functions
615 series ANSI 77
Technical Manual
To Next Page
Loading...
