165
Regardless of which tool is selected, you can do any of the following to move, lengthen, shorten, or transpose any
selected note/notes.
To automatically set the grid to view one pad bank and two bars, tap the grid-and-magnifying-glass icon in
the lower-left corner.
To undo your last action, press Undo.
To redo the last action you undid, press and hold Shift, and then press Undo/Redo.
To select all notes for a pad, press the desired pad.
To move the selected notes, tap Nudge at the bottom of the screen, and then use the data dial or –/+ buttons
to shift the notes left or right. By default, you can position notes only by quantization values defined by the Time
Correct value (see General Features > Timing Correct (TC) to learn about this).
To move the selected notes without restricting (“snapping”) them to the quantization grid, tap and hold
Don’t Snap in the lower-left corner of the screen, and then use the data dial or –/+ buttons to shift the notes. In
this case, each nudge is equivalent to four ticks.
To adjust the start point or end point of the selected notes (without changing their position), tap Edit Start at
the bottom of the screen, and then use the data dial or –/+ buttons.
To transpose the selected notes up or down, tap Transpose at the bottom of the screen, and then use the
data dial or –/+ buttons.
To copy the selected notes instantly, press Copy. The selected notes will be duplicated and start immediately
after the end of the last selected note. Nudge will be automatically selected so you can immediately use the data
dial to move the copied notes,
To switch to the previous or next track, press and hold Shift, and then tap Track – or Track + (respectively) at
the bottom of the screen.
To mute or solo the track
, press and hold Shift, and then tap Mute or Solo (respectively) at the bottom of the
screen.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
