166
To open the Timing Correct window, press and hold Shift, and then tap TC at the bottom of the screen. See
General Features > Timing Correct (TC) to learn about this.
To select a time division directly, double-tap the down arrow () in the upper-left corner of the grid and select a
time division.
To adjust the metronome settings, press and hold Shift, and then tap Click at the bottom of the screen. See
General Features > Metronome (Click/Metro) to learn about this.
The Grid View also contains a velocity/automation lane where you can easily adjust note velocities and automation
parameters.
The velocity lane in the Grid View.
To show or hide the velocity/automation lane:
1. Tap the up arrow (∧) button in the lower-right corner to show the velocity/automation lane.
2. Tap the down arrow (∨) to hide the velocity/automation lane.
When viewing velocity in the lane, a vertical bar represents each note’s velocity. The higher and more red the bar is,
the higher the velocity is. Yellow bars indicate a lower velocity. Bars with a gray line at the top indicate a currently
selected note.
To adjust the velocity of the selected notes, tap Velocity at the bottom of the screen, and then use the data dial
or –/+ buttons. The numeric value will appear on the screen.
See Addenda > Updates in MPC 2.6 > New Features > Grid Automation Lanes for more information on editing
automation parameters.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
