417
Trem/Tube/Chorus
Use this tab to apply and adjust the settings for the built-in Tremolo, Tube (Overdrive), and Chorus effects.
Parameter Description Value Range
Tremolo Rate Modulation speed of the effect.
When Sync is set to Free:
0.25 – 13.00 Hz
When Sync is set to S
nc:
8/4 – 1/16
Sync
Sync the Tremolo Rate to the Global Tempo or let it
run Free.
Free, Sync
Mode
Select Pan for stereo field modulation, or Tremolo for
amplitude modulation.
Pan, Tremolo
Depth
mount of modulation applied. 0–100%
Tube Drive
mount of drive applied. 0–100%
Headroom Amount of gain reduction between the clean signal
and the driven signal.
-30.0 – 0.0 dB
Saturation
mount of saturation applied. 0–100%
Output Output level of the tube driven signal. -20.0 – 0.0 – +20.0 dB
Chorus Rate Modulation speed of the effect. 0.40 – 3.20 Hz
Depth
mount of pitch modulation of the effect. 0–100%
Mix Wet/dry amount of the chorus effect. 0–100%
Delay
Use this tab to apply and adjust the settings for the built-in Delay effect.
Parameter Description Value Range
Time
mount of time between the dry si
nal and the delayed si
nal.
When Sync is set to Free:
1 ms – 2.00 s
When Sync is set to Sync:
1/32 – 8/4
Sync
Sync the Delay Time to the Global Tempo or set to Free to adjust Time
by milliseconds.
Free, Sync
Mix Wet/dry amount of the delay effect. 0–100%
Feedback Amount of signal fed back into the delay line. 0–100%
Damp Center frequency of where the delay si
nal will be dampened. 1.00–20.0 kHz
Reso
mount of resonance of the feedback si
nal. 0–100%
Reso Freq Center frequency for feedback resonance. 100 Hz – 10.0 kHz
Ratio
Reduces the delay Time in either the Left or Right stereo field. This is
useful for creating offset, panned delays.
L 50:100, R 50:100
HPF Center frequency for delay signal high-pass filter. 20.0 Hz – 1.0 kHz
Width Stereo width of delay si
nal. Hi
her values
ive wider stereo separation. 0–100%
To Next Page
Loading...
Need help?
General
Weight and Dimensions
