Akai MPC Live - Page 422

422
LFO
Use this tab to adjust the settings for the low-frequency oscillators.
Parameter Description Value Range
LFO 1/LFO 2 Shape Waveshape of the low-frequency oscillator. Sine, Square. Saw
Up, Saw Down,
Pump, S&H, Drift
Destination Where the low-frequency oscillator is sent.
LFO1:
Off, Pitch, Filter,
Level, Pan
LFO2:
Pitch, Osc 1/2 Shape,
Osc 1/2 Pitch, LPF,
Quad Detune, Osc
EQ Freq, Osc 2 EQ
Gain, Rin
g
Level
Rate Speed of modulation.
When Sync is Off:
0.01 – 20.00 Hz
When Sync is On:
8/4 – 1/32
Depth Amount of modulation applied. 0–100%
Fade Apply a fade-in or fade-out of the LFO signal. 0.00 – 20.00 s out,
No fade,
0.00 – 20.00 s in
Sync
Sync the LFO Rate to the Global Tempo or turn Off to
adjust Rate by Hertz.
Off, On
Modulation Source Where the modulation signal is sent from. Filter Env, Amp Env,
Osc 1, Osc 2
Destination Where the modulated signal is received. Pitch, Osc 1/2 Shape,
Osc 1/2 Pitch, LPF,
Quad Detune, Osc
EQ Freq, Osc 2 EQ
Gain, Ring Level
Depth
A
mount of modulation applied. 0–100%