Akai MPC Live - Page 423

423
Setup
Use this tab to adjust plugin setup parameters.
Parameter Description Value Range
Controller Destinations
Velocity 1 Send Velocity data to one of the following control
destinations.
Amp, Cutoff, Osc1
Shape, Osc2 Shape,
Osc1&2 Shape
Depth Amount of modulation applied. 0–100%
Velocity 2 Send Velocity data to one of the following control
destinations.
Amp, Cutoff, Osc1
Shape, Osc2 Shape,
Osc1&2 Shape
Depth
A
mount of modulation applied. 0–100%
Modwheel Send Modwheel data to one of the following
control destinations.
Amp, Cutoff, Osc1
Shape, Osc2 Shape,
Osc1&2 Shape
Depth
A
mount of modulation applied. -100 – 0 – 100%
Aftertouch Send Aftertouch data to one of the following
control destinations.
LFO 1 Depth, Cutoff,
Osc1 Shape, Osc2
Shape, Osc1&2 Shape
Depth Amount of modulation applied. -100 – 0 – 100%
Setup Polyphony Number of allowable voices, and how voices are
triggered.
Legato, Retrigger, 2, 3, 4
Bend Range Number of semitones up or down controlled by
MIDI pitch bend messages.
0–12 (semitones)
Glide Time Amount of time to slide from the pitch of one note
to the next note played.
1.00 ms – 100 s
Glide All Enables or disables pitch gliding for all triggered
notes, not just le
g
ato notes.
Off, On
Detune Amount of detuning applied. This setting is only
applied when Doubling is enabled.
0–100%
Doublin
g
Enables or disables voice doublin
g
. Off, On
Output Shape
A
mount of si
g
nal sent to a Tube Drive. 0–100%
Width Stereo width of the audio signal. Higher values
give wider stereo separation.
0–100%
Level Overall output volume of the plu
g
in. -Inf dB – +12.0 dB