466
You can also use the DrumSynth:Multi plugin to access
all DrumSynth sounds from one plugin, which includes
additional dedicated effects and mixing controls.
Note: You can only have one DrumSynth:Multi plugin
active per project when in Standalone mode.
DrumSynth 1–8 / Trans/Dist / EQ/Comp
Use the first eight tabs in the Multi to control the same
parameters as the individual DrumSynth plugins. Tap
each tab to cycle between the Drum Sound view, the
Trans/Dist view, and the EQ/Comp view.
Send FX
Use this tab to adjust the settings for the Delay, Diffuser and Reverb effects.
Parameter Description Value Range
Delay Time Length of time between the dry signal and the
delayed signal.
1/32 – 8/4
Ratio
Reduces the delay Time in either the Left or
Right stereo field. This is useful for creating
offset, panned delays.
L 100:50, R 50:100
Feedback Amount of delay signal fed back into the
delay line.
0–100%
Filter Freq Sets the center frequency of the filtered delay
signal.
1.00 – 20.0 kHz
Reso Amount of resonance of the feedback signal. 0–100%
Reso Freq Center frequency for feedback resonance. 100 Hz – 10.0 kHz
Diffuser Delay Delay time between the dry signal and the
diffused signal.
1/64 – 4/4
Feedback Amount of diffused signal sent back into the
delay line.
0–100%
Diffusion Rate of increasing density of reverb
reflections.
At lower settings, the sound of individual
reflections is more present.
At higher settings, reflections are more
uniform.
0–100%
Bright Adjusts the high-end tone of the diffused
signal.
0–100%
Reverb Mode Type of reverb applied. Hall, Stadium, Room,
Abstract
Time Length of reverb tail. 0.4 s – +Inf s
Low Cut Center frequency for the reverb low-pass
filter.
1 – 1000 Hz
High Cut Center frequency for the reverb high-pass
filter.
1.00 – 20.0 kHz
To Next Page
Loading...
Need help?
General
Weight and Dimensions
