Name: Akai MPC Live
Brand: Akai
Rating: 4 (1 reviews)

To Next Page

To Previous Page

470

AIR Hype (continued)

Effects 1

Use this tab to adjust the settings for the Low-Frequency Oscillator

and Modulation, Distortion and Hype effects.

Parameter Description Value Range

LFO Rate Speed of the low frequency oscillator.

When Sync is set to 1st Note, Each Note, or Off:

0.03 – 30.00 Hz

When Sync is set to Temp+Note or Tempo+Beat:

8/4 – 1/64

Sync Enables or disables LFO sync, and sets how it is

synced when enabled.

Off, 1st Note, Each Note,

Tempo+Note, Tempo+Beat

Depth

mount of LFO modulation applied. 0–100%

Mod Rate Speed of modulation. 0.05 – 20.00 Hz

Adjust Length of time the wet signal is offset from the dry

nal.

0.0 – 24.0 ms

Depth Amount of modulation applied. 0–100%

Mix Wet/dry mix of the modulation effect. 0–100%

Distortion Drive

mount of drive applied. 0–100%

Bias Emulates amount of voltage sent to a tube power-

amp.

-100 – 0 – 100%

Output Output level of the distorted si

nal. 0–100%

Mix Wet/dry mix of the distortion effect. 0–100%

Hype Low Dampens or maximizes low end frequencies. -12.0 – 0.0 – +12.0 dB

Lo-Mid Dampens or maximizes low-mid frequencies. -20.0 – 0.0 – +20.0 dB

Hi-Mid Dampens or maximizes high-mid frequencies. -20.0 – 0.0 – +20.0 dB

h Dampens or maximizes hi

h end frequencies. -12.0 – 0.0 – +12.0 dB

Other manuals for Akai MPC Live

Questions and Answers:

Need help?

Do you have a question about the Akai MPC Live and is the answer not in the manual?

General