501
When the Program source is selected, and a Pad is selected:
Off
Mixer: Level, Pan, Pad Mute, Pad Solo, Send 1–4
Program:
Tuning Filter Env Decay Curve Layer Fine Tune (1–4) Layer Offset (1–4)
Filter Cutoff Filter Env Release Curve Velocity to Start Layer Loop Xfade (1–4)
Filter Resonance Pitch Env Attack Vel to Filter Attack Layer Loop Xfade Type (1–4)
Filter Env Amount Pitch Env Hold Velocity to Env Amount Layer Slice Tail Length (1–4)
Amp Env Attack Pitch Env Decay Velocity to Filter Layer Slice Tail Start (1–4)
Amp Env Decay Pitch Env Sustain LFO to Pitch Layer Pitch Random (1–4)
Amp Env Release Pitch Env Release LFO to Filter Layer Level Random (1–4)
Amp Env Hold Pitch Env Decay Mode LFO to Amp Layer Pan Random (1–4)
Amp Env Sustain Pitch Env Attack Curve LFO to Pan Layer Offset Random (1–4)
Filter Env Attack Pitch Env Decay Curve LFO Wave Attack Random
Filter Env Hold Pitch Env Release Curve LFO Rate Decay Random
Filter Env Decay Pitch Env Depth LFO Sync Cutoff Random
Filter Env Sustain Pitch Env Type Velocity to Pitch Resonance Random
Filter Env Release DrumFX (1–8) Vel to Volume Attack Total Random Amount
Amp Env Attack Curve DrumFX Type (1–8) Velocity to Amp LFO Level
Amp Env Decay Curve Layer Level (1–4) Velocity to Pan LFO Delay
Amp Env Release Curve Layer Sample Pan (1–4) Layer Slice (1–4) LFO Fade In
Filter Env Attack Curve Layer Semi Tune (1–4) Layer Reverse (1–4)
Insert 1–4: Other available parameters depending on the effect
When the Return source is selected:
Off
Mixer: Volume, Pan, Mute
Insert 1–4: Other available parameters depending on the effect
When the Submix source is selected:
Off
Mixer: Volume, Pan, Mute, Send 1–4
Insert 1–4: Other available parameters depending on the effect
When the Main source is selected:
Off
Mixer: Volume, Pan, Mute
Insert 1–4: Other available parameters depending on the effect
Momentary: Check this box to turn momentary behavior on or off.
When on, moving your finger along the touch strip will adjust its parameter, but the parameter will
immediately return to its original position (when you turned Momentary on) when you release your finger from
the touch strip.
When off, moving your finger along the touch strip will adjust its parameter, and the parameter will remain at
its new setting when you release your finger from the touch strip.