Introduction Configuring SNTP
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-72
The following procedure shows the commands used for adding an SNTP server, enabling SNTP, and modifying
the system timezone.
TABLE 1-10 Configuration Procedure for SNTP
Step Command Description (Optional)
Review the default SNTP settings before configuring
1
SHOW SNTP
SNTP Configuration
------------------------------------------------------------------------------
Status Off
Local IP 10.52.70.14
Last Update -
Last Delta -
Last Status -
SNTP Server
------------------------------------------------------------------------------
No SNTP Server Configured
SNTP Statistics
------------------------------------------------------------------------------
Requests Sent 0
Responses Received 0
Set up the configuration for SNTP. These commands are normally issued during system setup
2
>ENABLE TELNET SERVER
>ADD IP INTERFACE=MGMT IPADDRESS=10.52.70.14 SUBNETMASK=255.255.255.0
CARD=ACTCFC GATEWAY=10.52.70.1 IFNAME=MGMT MANAGEMENT=Yes
>ENABLE IP INTERFACE=MGMT
Add the SNTP server (by specifying an IP address or hostname)
3
ADD SNTP SERVER=192.43.244.18 Specifies the hostname or IP address of the SNTP
server that the SBx3112 system will use.
Enable the SNTP server
4
ENABLE SNTP Activates the SNTP so that the SBx3112 will be
able to synchronize its clock with the SNTP clock.
Note the results
To Next Page
Loading...
Need help?
General
