Introduction CFC Media (SD Card)
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-98
COPY FILE TO
Syntax
COPY FILE={ sourcefile | unit:sourcefile } TO={ destinationfile |
unit:destinationfile }
Description Copies the specified source file to the specified destination file. The command is rejected
if there is insufficient space on the CFC flash file system for the new file. If either the
source file or destination is a media card, the file name should be directly preceded by
the unit name. For example,
COPY FILE SD5:myFile to myFile would copy the file
“myFile” from the SD card associated with CFC 5 to local flash.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example COPY FILE SD5:D104.CFG TO D104.CFG
Option Description Default Value
FILE The name of the file that is being copied from. The unit
is the SD card and the number of the CFC slot (e.g.,
SD4).
TO The name of the file that the file is being copied to. The
unit is the SD card and the number of the CFC slot (e.g.,
SD4).
If only the filename is specified, the file is copied to
FLASH memory.
To Next Page
Loading...
Need help?
General
