Allied Telesis SwitchBlade x3100 Series - Page 132

Introduction CFC Media (SD Card)
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-102
GET FILE
Syntax
GET FILE={ sourcefilename | serverpath/sourcefilename } { TFTP
SERVER={ ipaddress | hostname } | ZMODEM | FTP SERVER={ ipaddress |
hostname } USER=userid PASSWORD=password } [ TO=unit: ]
Description Used to transfer files onto either the CFC flash file system or, (if the optional TO param-
eter is used) a specified media card, from the specified SERVER, using the specified file
transfer METHOD. The command fails if there is insufficient space on the CFC flash file
system or SD card, or if the filename is the same as a pre-existing preferred load file for
a provisioned card. For an SBx3112 with redundant CFCs, the operation is performed on
both CFCs when they are both ONLINE.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example GET FILE D104_14.1.0_19JULY.CFG TFTP SERVER 10.52.65.42 TO
SD5:
Option Description Default Value
FILE The file that is either on the CFC FLASH (sourcefile-
name) or on the server that is designated by the path.
TFTP SERVER The ip address or name of the tftp server.
ZMODEM Specifies the file should be transferred using the ZMO-
DEM protocol.
FTP SERVER The ip address or name of the tftp server.
USER The user id to gain access to the specified server.
PASSWORD The password needed after entering the user id to gain
access to the specified server
TO The SD card that will receive the file from the specified
server.