Allied Telesis SwitchBlade x3100 Series - Page 133

CFC Media (SD Card) Introduction
1-103
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
PUT FILE
Syntax
PUT FILE={sourcefile|unit:sourcefile} {TFTP SERVER={ipaddress|host-
name} | FTP SERVER={ipaddress|hostname} USER=userid PASSWORD=pass-
word | ZMODEM} [TO=serverpath]
Description Transfers the specified file from the CFC flash file system or specified SD card to the
given destination. The destination is either an external server, or a card or set of cards in
the shelf. The source file must already exist on the flash file system.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example PUT FILE SD5:D104_14.1.0.CFG TFTP SERVER 10.52.65.42 TO LOG-
FILES/D104_14.1.0.CFG
Option Description Default Value
FILE The file that is either on the CFC FLASH (sourcefile-
name) or on the server that is designated by the path.
TFTP SERVER The ip address or name of the tftp server.
ZMODEM Specifies the file should be transferred using the ZMO-
DEM protocol.
FTP SERVER The ip address or name of the tftp server.
USER The user id to gain access to the specified server.
PASSWORD The password needed after entering the user id to gain
access to the specified server
TO The SD card that will receive the file from the specified
server.