Introduction CFC Media (SD Card)
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-104
PUT FILE CARD
Syntax
PUT FILE={ sourcefile | unit:sourcefile } CARD={ slot | slot-list }
Description Transfers the specified file from the CFC flash file system or specified SD card to the
given destination. The destination is a card or set of cards in the shelf. The source file
must already exist on the flash file system.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example PUT FILE SD5:D104_14.1.0.CFG CARD 10-11
Option Description Default Value
FILE The file name on the CFC FLASH memory. The unit can
also be included.
CARD The slot(s) of the cards that will receive the file.
To Next Page
Loading...
