To Next Page

To Previous Page

Introduction XE4 Card Attributes

Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)

1-238

CREATE PROFILE

Syntax

CREATE PROFILE=name cardtype [ PREFLOAD=filename ] [ ADMINSTATE={

UP | DOWN } ]

Description Creates a profile for the specified card type. Attributes required are usually the PREF-

LOAD and ADMINSTATE.

Options The following table gives the range of values for each option that can be specified with

this command and a default value (if applicable).

Example CREATE PROFILE=GOLD GEPORT FLOWCONTROL=ON

Option Description Default Value

PROFILE A profile contains a set of pre-defined provisioning

attributes. The contents of a profile can be displayed

(SHOW PROFILE) and changed (SET PROFILE).

card_type The type of card. For the SBx3112, the allowed card

types are GE24POE, GE24SFP, and XE4.

N/A

PREFLOAD Specifies the name of the preferred software load file for

the card. This file must reside on the CFC flash file sys-

tem, and is loaded to the flash memory on the card (if

it's not already there) when the card is enabled or reset.

The command is rejected if the preferred software load

specified is not compatible with the specified card.

ADMIN-

STATE

The initial administrative state for the card. The adminis-

trative state reflects the user's intent on having the card

available for service (ready to process data).

Allied Telesis SwitchBlade x3100 Series User Manual

Questions and Answers: