Introduction XE4 Card Attributes
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-244
RESTART SYSTEM FORCE
Syntax
RESTART SYSTEM [ FORCE ]
Description Restarts the system. If the command is executed on a duplex system, avoiding the
requirement to restart both the ACTCFC and INACTCFC
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example RESTART SYSTEM
Option Description Default Value
FORCE Performs the reset without the confirmation message.
To Next Page
Loading...
