Allied Telesis SwitchBlade x3100 Series - Page 279

XE4 Card Attributes Introduction
1-249
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
SHOW CARD ACTCFC
--- Card Information ---
Slot............................... 5
Type............................... CFC200
State.............................. UP-UP-Online (Active)
Provisioning Profile............... AutoProv
Hardware
Model Number (Revision)......... AT-SBxMFC (Rev X2)
Serial Number................... 51
CLEI Code....................... <none>
Software
Running Load.................... cfc200_14.2.0.kmartin.20100401_KWM.tar
Preferred Load.................. cfc200_14.2.0.kmartin.20100401_KWM.tar
Temporary Load.................. None
Alternate Load.................. None
Software Build Information
Load File....................... cfc200_14.2.0.kmartin.20100401_KWM.tar
Build Name...................... ATI 200G Central Fabric Controller
Build Type...................... Lab-Only Build
Revision........................ 14.2.0.GAMMA.20100401
Built On........................ Fri 04/30/2010 at 03:20 PM
Built By........................ kmartin
Environment..................... kmartin_R14.2_Dev1
Baseline........................ R14.2.0_2010_04_01_Nightly
Boot ROM Build Name............. ATI 200G Central Fabric Controller Boot
Loader
Boot ROM Version................ 14.1.g.01
Card Type Specific Information
Timing Reference................ N/A
SHOW CARD=5 // The same output as with SHOW CARD=ACTCFC
--- Card Information ---
Slot............................... 5
Type............................... CFC200
State.............................. UP-UP-Online (Active)
Provisioning Profile............... AutoProv
Hardware
Model Number (Revision)......... AT-SBxMFC (Rev X2)