Introduction XE4 Card Attributes
Software Reference for SwitchBlade x3100 Series Switches (Setting Up the Switch)
1-248
SHOW CARD
Syntax
SHOW CARD [ ={ slot-list | ACTCFC | INACTCFC | ALL } ] [ { INVEN-
TORY | SOFTWARE | FULL } ]
Description Displays various information about the provisioned card in the specified slot. Entering
the command with no optional parameters displays basic information about the card.
Optional parameters are provided to display additional information.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
Option Description Default Value
CARD The slot number of the card(s) to be reset. The list must
not include the slots for the ACTCFC or INACTCFC
ACTCFC The active CFC
INACTCFC For a dual configuration, the inactive CFC (although it is
still load-sharing if in service).
ALL The SHOW CARD ALL command displays a summary
of cards present in the shelf. Entering SHOW CARD
ALL command without the optional INVENTORY
parameter displays the following information for each
slot in tabular format:
- slot number
- provisioned card type
- current state of the card, in the format of hyphen sep-
arated administrative state, operational state, and status
attribute (for example, UP-UP-ONLINE)
- current faults against the card
INVENTORY Entering the SHOW CARD ALL command with the
optional INVENTORY parameter displays the following
information for each slot in tabular format:
- slot number
- provisioned card type
- model number (read from the IDPROM on the card)
- serial number (read from the IDPROM on the card
SOFTWARE Show the software loads of the cards
FULL Show a full display without summaries
To Next Page
Loading...
Need help?
General
