GE Interfaces Example Output
Software Reference for SwitchBlade x3100 Series Switches (Interface Management)
2-10
DISABLE INTERFACE
Syntax
DISABLE INTERFACE={ type:id-range | id-range | ifname-list } [
FORCE ]
Description This command should be used with caution. Places the interface(s) in the DOWN
administrative state. FORCE will do this even is the interface is operationally UP.
Note: Disabling the GE24POE interface has no effect on the port’s ability to provide power.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
DISABLE INTERFACE=1.2 FORCE
Info (039512): Operation Successful (XE4 Slot 1 Port 2)
Option Description Default Value
INTERFACE The INTERFACE parameter allows the filtering of inter-
faces. Interfaces to be displayed may be selected by type
or a type:id/name list (e.g., ETH:4.4-4.8/name1,name2)
ALL
FORCE Will disable the interface even if it is operationally UP.
To Next Page
Loading...
Need help?
General
