Allied Telesis SwitchBlade x3100 Series - Page 298

GE Interfaces Example Output
Software Reference for SwitchBlade x3100 Series Switches (Interface Management)
2-18
SET INTERFACE REMOTEID
Syntax
SET INTERFACE={ type: | type:id-range | id-range | ifname-list |
ALL }
REMOTEID={ remote-id | NONE }
Description Sets the remote id for the interface
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example SET INTERFACE=ETH:0.23 REMOTEID=DVLK-x3112-A01
Option Description Default Value
REMOTEID Used by DHCP servers to identify a RELAY AGENT.
Setting this parameter is optional. The default is the
MAC address of the switch the RELAY AGENT is run-
ning on. The user can specify the REMOTEID by enter-
ing a string of 1 to 31 ASCII characters.
NONE