Configuration Guidelines Configuring the GE24POE Card
3-15
Software Reference for SwitchBlade x3100 Series Switches (Power over Ethernet (PoE))
SHOW POE COUNTER INTERFACE
Syntax
SHOW POE COUNTER INTERFACE [ ={ type:id-range | id-range | ifname-
list | ALL } ]
Description Shows the counters for the POE interface(s).
PoE counters are fault and status events. These are defined as follows:
• MPS Absent - Maintenance power signature is the signal a PD sends to the switch to
indicate that the PD is connected and requires power; indicates the number of times a
detected PD has no longer requested power from the port
• Invalid - indicates a fault with the connected PD
• Denied - the number of times PDs requesting power on the port have been denied due
to insufficient power available
• Overload - the number of times a connected PD attempted to draw more than 15.4
watts
• Short - the number of times the switch provided insufficient current to a connected PD
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
officer SEC>> SHOW POE COUNTER INTERFACE=1.0-1.4
--- PoE Interface Counters ---------------------------------------
Interface MPS Absent Invalid Denied Overload Short
----------- ------------ --------- --------- ---------- --------
1.0 12 0 0 0 0
1.1 - - - - -
1.2 6 3 3 0 0
1.3 0 0 0 0 1
1.4 0 0 0 0 0
Option Description Default Value
INTERFACE A logical representation of one or more physical ports
type:id-range - the type of available ports, such as
ETH:7.0 or a range (ETH:8.0-8.9)
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - all applicable interfaces in the system
To Next Page
Loading...
