Allied Telesis SwitchBlade x3100 Series User Manual

Configuring LAG Introduction
4-33
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
4.3.4 LAG Command List
The following tables list the commands available to configure and manage LAG on the SBx3112 switch.
The following table describes the global hash selection settings that are available with the SET SWITCH HASH
SELECT command, and the corresponding display in the SHOW LAG command:
TABLE 4-5 LAG Commands
Commands
ADD LAG INTERFACE
CREATE LAG
DELETE LAG
DESTROY LAG
RESET LAG COUNTER
SET LAG
SET SWITCH HASH SELECT
SHOW LAG
TABLE 4-6 SBx3112 - SET SWITCH HASH SELECT Parameters
Parameter Value LAG Hashing Behavior
MAC macsrc & macdest Hash based only on layer 2 source and destination MAC in packet
IP ipsrc & ipdest Hash based on layer 3 source and destination IP in packet. If layer 3 data
is not present in the packet, hash based on layer 2 source and destination
MAC
MACANDIP ipboth & macboth Hash based on both source and destination MAC and IP. If layer 3 data is
not present in the packet, hash based on layer 2 source and destination
MAC

Allied Telesis SwitchBlade x3100 Series Specifications

General

Brand	Allied Telesis
Model	SwitchBlade x3100 Series
Category	Switch
Language	English