Allied Telesis SwitchBlade x3100 Series - Page 359

Configuring LAG Introduction
4-39
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
RESET LAG COUNTER
Syntax
RESET LAG COUNTER={LACPSTATS|MACSTATS|ALL}
Description This command clears Link Aggregation Group (LAG) statistics. Link Aggregation Control
Protocol (LACP) and Medium Access Control (MAC) statistics are cleared independently
or simultaneously, as specified by user.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
RESET LAG COUNTER=ALL
Option Description Default Value
COUNTER The counters for the LAG-related statistics
LACPSTATS - LACP statistics for the LAG, such as
LACP packets transmitted, received, and errored. This
keyword is applicable only if LAG mode is set to active
or passive (indicating that LACP is configured to run on
system).
MACSTATS - MAC statistics for the LAG, such as MAC
uni/multi/broad-cast packets received/transmitted, and
octets received/transmitted counts.
ALL