Introduction Configuring LAG
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
4-38
DESTROY LAG
Syntax
DESTROY LAG=lagname
Description This command destroys a LAG. The LAG mode must be set to OFF prior to destroying
the LAG. This can be accomplished with the SET LAG command. It is necessary to delete
all interfaces from the LAG prior to destroying it. The member interfaces must be
deleted form the LAG using the DELETE LAG INTERFACE command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
DESTROY LAG=card1_card8
Option Description Default Value
LAG The lagname already created.
To Next Page
Loading...
