Introduction Configuring BPDU Cop
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
4-98
ADD TRACE STP
Syntax
ADD TRACE STP [ INSTANCE={ stpname | mstid | MAIN | ALL } ] [
EVENT={ BPDU | ALL } ] [ INTERFACE={ type:id-range | id-range |
ifname-list | ALL } ]
Description Adds filter criteria for which Spanning Tree Protocol traces to generate. BPDU traces
can be filtered by MST instance, and/or by interface. You then can use the ENABLE
TRACE OUTPUT=CLI to view the output
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example ADD TRACE STP INTERFACE 0.22
Option Description Default Value
INSTANCE The Spanning Tree Instance of the trace
EVENT The event trace to add ALL
INTERFACE The interface against which the trace will be
applied
To Next Page
Loading...
