Introduction Configuring BPDU Cop
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
4-106
RENAME STP INSTANCE
Syntax
RENAME STP INSTANCE={ stpname | mstid } TO=stpname
Description Rename the STP instance (using the name or id to specify) to another name. When the
name is changed, all the associated interface information is changed as well.
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example (Renaming mst9 to msttst)
rename stp instance mst9 to msttst
Info (010017): Operation Successful
show stp inst all
--- STP Information ----------------------------------------
Spanning Tree Type...................... MSTP (CIST)
(information omitted)
--- STP Information ---------------------------------------
Spanning Tree Type...................... MSTP (MSTI)
Instance Name......................... msttst (9)
Instance State........................ ENABLED
Regional Root Bridge ID Priority........ 9
Regional Root Bridge ID MAC Address... 00:0C:25:04:01:AB
Max Age (seconds)..................... 20
Hello Time (seconds).................. 2
Forward Delay (seconds)............... 15
Bridge ID Priority...................... 9 (priority 0 mstid 9)
Bridge ID MAC Address................. 00:0C:25:04:01:AB
Bridge Max Age (seconds).............. 20
Bridge Hello Time (seconds)........... 2
Bridge Forward Delay (seconds)........ 15
Int Role State Cost Prio.Number Type
----- ---------- ---------- ---------- ----------- ------------
8.1 DESIGNATED FORWARDING 200000 128.834 MSTP
Option Description Default Value
INSTANCE The original instance name.
TO The new name for the instance.
To Next Page
Loading...
