Configuring BPDU Cop Introduction
4-107
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
RESET STP
Syntax
RESET STP [ { INSTANCE={ stpname | mstid | MAIN | ALL } | LEARN-
CISCODIGEST } ]
Description Resets the counters for the default STP instance and forces the spanning tree algorithm
to restart. This causes this bridge to temporarily assume the role of “root bridge” and
declare all its ports as “designated ports”, as would happen when the bridge is powered
cycled or rebooted.
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example RESET STP INSTANCE=
msttst
Option Description Default Value
INSTANCE The instance to be reset.
LEARN-
CISCODI-
GEST
Specifies the Cisco MST configuration digest for the
bridge that should be copied/stored.
To Next Page
Loading...
