Configuring SuperLoop Introduction
4-141
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
8
show vlan
--- VLAN Information -------------------------------------------------------------------------
Name VID Forwarding Tagged Interfaces Untagged Interfaces
Mode
--------------- ---- ---------- ------------------------------- -----------------------------
default 1 Standard <none> ETH:[0.1-3],[1-2,6-7,10-11.0-3],
[3,8-9.0-1,3-23]
vlan6 6 Standard ETH:[0.0],[3,8-9.2] <none>
vlan20 10 Standard ETH:[3,8-9.2] <none>
vlan200 200 Standard ETH:[3,8.2] <none>
vlan300 300 Standard ETH:[3,9.2] <none>
Set GE interfaces to the NETWORK direction
9
set interface 8.2 ge direction network
set interface 9.2 ge direction network
set interface 3.2 ge direction network
Configures the GE interfaces for the Network
direction.
Add interfaces to the “allied-1” domain
10
ADD EPSR=allied-1 INTERFACE=ETH:[8.2]
ADD EPSR=allied-1 INTERFACE=ETH:[3.2]
Adds interfaces 8.2 and 3.2 to the “allied-
1” EPSR domain.
Add interfaces to the “allied-2” domain
11
ADD EPSR=allied-2 INTERFACE=ETH:[9.2]
ADD EPSR=allied-2 INTERFACE=ETH:[3.2]
Adds interfaces 9.2 and 3.2 to the “allied-
2” EPSR domain.
Add control VLAN to the “allied-1” domain
12
ADD EPSR=allied-1 VLAN=200 TYPE=CONTROL Adds VLAN 200 to the “allied-1” EPSR
domain as the control VLAN.
Add the data VLANs to the “allied-1” domain
13
ADD EPSR=allied-1 VLAN=6 TYPE=DATA
ADD EPSR=allied-1 VLAN=20 TYPE=DATA
Adds VLAN 6 to the “allied-1” EPSR
domain as a data VLAN.
Adds VLAN 20 to the “allied-1” EPSR
domain as a data VLAN.
Review configuration information for the “allied-1” domain
TABLE 4-19 Configuration Procedure for SuperLoop - Peer SuperLoop Domain
Step Command Description
To Next Page
Loading...
