Allied Telesis SwitchBlade x3100 Series - Page 462

Introduction Configuring SuperLoop
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
4-142
14
show epsr allied-1
--- EPSR Domain Information ---
EPSR Domain Name...................... allied-1
EPSR Domain Node Type................. Transit
EPSR Domain State..................... IDLE
MAC Address of Master Node............ 00:00:00:00:00:00
EPSR Domain Status.................... Disabled
Control Vlan.......................... 200
Enhanced Recovery..................... ON
Ring Interface # 1.................... ETH:[8.2]
Physical State of Ring Interface # 1.. UP
Ring Interface # 1 Type............... RING
Ring Interface # 1 State.............. PHYSICALLY FORWARDING
Ring Interface # 1 Priority........... 0
Ring Interface # 1 Priority Rank...... 0
Ring Interface # 2.................... ETH:[3.2]
Physical State of Ring Interface # 2.. UP
Ring Interface # 2 Type............... RING
Ring Interface # 2 State.............. PHYSICALLY FORWARDING
Ring Interface # 2 Priority........... 0
Ring Interface # 2 Priority Rank...... 0
Data Vlans............................ 6, 20
Add the control VLAN to the “allied-2” domain
15
ADD EPSR=allied-2 VLAN=300 TYPE=CONTROL Adds VLAN 300 to the “allied-2” EPSR
domain as the control VLAN.
Add the data VLANs to the “allied-2” domain
16
add epsr allied-2 vlan 6 type data
add epsr allied-2 vlan 20 type data
Adds VLAN 6 to the “allied-2” EPSR
domain as a data VLAN.
Adds VLAN 20 to the “allied-2” EPSR
domain as a data VLAN.
Review configuration information for the “allied-2” domain
TABLE 4-19 Configuration Procedure for SuperLoop - Peer SuperLoop Domain
Step Command Description