Allied Telesis SwitchBlade x3100 Series - Page 463

Configuring SuperLoop Introduction
4-143
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
17
show epsr allied-2
--- EPSR Domain Information ---
EPSR Domain Name...................... allied-2
EPSR Domain Node Type................. Transit
EPSR Domain State..................... IDLE
MAC Address of Master Node............ 00:00:00:00:00:00
EPSR Domain Status.................... Disabled
Control Vlan.......................... 300
Enhanced Recovery..................... ON
Ring Interface # 1.................... ETH:[9.2]
Physical State of Ring Interface # 1.. UP
Ring Interface # 1 Type............... RING
Ring Interface # 1 State.............. PHYSICALLY FORWARDING
Ring Interface # 1 Priority........... 0
Ring Interface # 1 Priority Rank...... 0
Ring Interface # 2.................... ETH:[3.2]
Physical State of Ring Interface # 2.. UP
Ring Interface # 2 Type............... RING
Ring Interface # 2 State.............. PHYSICALLY FORWARDING
Ring Interface # 2 Priority........... 0
Ring Interface # 2 Priority Rank...... 0
Data Vlans............................ 6, 20
Set the priority for the “common” link (shared by both domains)
18
SET EPSR=allied-1 INTERFACE=ETH:[3.2]
PRIORITY=10
Makes the “allied-1” EPSR domain the low-
priority ring (by assigning it a priority of 10).
19
SET EPSR=allied-2 INTERFACE=ETH:[3.2]
PRIORITY=11
Makes the “allied-2” EPSR domain the high-
priority ring (by assigning it a higher priority of
11).
Enable both EPSR domains
20
ENABLE EPSR=allied-1,allied-2 Enables the “allied-1” and “allied-2”
EPSR domains on System A.
Note: This enable command must be issued
with both domains specified at the same time.
Review data VLANs per EPSR domain
21
show epsr datavlans
--- EPSR Domain Information ---
EPSR Domain Overlapping Domain(s)/Shrd Ring Port Data Vlans
----------- ------------------------------------ ------------
allied-1 allied-2/3.2 6,20
allied-2 allied-1/3.2 6,20
TABLE 4-19 Configuration Procedure for SuperLoop - Peer SuperLoop Domain
Step Command Description