Allied Telesis SwitchBlade x3100 Series - Page 479

EPSR and (R)STP Interaction Introduction
4-159
Software Reference for SwitchBlade x3100 Series Switches (Layer Two Switching)
ENABLE EPSR
Description Used to enable the EPSR domain. Before any EPSR domain can be enabled, the Control
Vlan, Primary and Secondary interfaces should have been provisioned on that EPSR
domain.
Syntax
ENABLE EPSR={ epsrdomain-list | ALL }
Options The following table gives the range of values for each option that can be specified with
this command and a Default Value (if applicable).
Example
ENABLE EPSR=allied-1,allied-2
Option Description Default Value
EPSR The name(s) that has been given to the EPSR
domain(s)
NA