Configuring ACL Introduction
6-49
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
SHOW ACCESSLIST
Syntax
SHOW ACCESSLIST={ accesslistname-list | ALL } [ INTERFACE={
type:id-range |id-range | ifname-list | ALL } ]
Description Displays data related to the configuration of ACCESSLISTs and (optionally) associations
by INTERFACEs There are two minor variations of this command: one that shows
ACCESSLIST data for each ACCESSLIST, and one that shows ACCESSLISTs in the con-
text of their associations to INTERFACEs. In both cases the command displays the
ACCESSLIST name, rules, and the action (PERMIT or DENY).
The second case (by INTERFACE) shows only ACCESSLISTs associated with the specified
INTERFACE(s). It also identifies any RULEs that were not able to be applied to the
INTERFACE's hardware, resulting in classifier configuration alarms.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SHOW ACCESSLIST stb_range
--- Access Lists ---------------------------------------------------------
Name Interfaces Rule Action Fields
--------- -------------- ---- ------- ------------------------------- ---
stb_range ETH:[10.0] 1 DENY APPLICATION=NETBIOS
2 PERMIT IPSOURCE=172.16.5.0
SOURCEMASK=255.255.255.240
3 PERMIT PROTOCOL=2054
-- DENY
Option Description Default Value
ACCESSLIST The ACCESSLIST Name that already exists. ALL
INTERFACE The interfaces that have associated ACCESSLISTs ALL
To Next Page
Loading...
Need help?
General
