Allied Telesis SwitchBlade x3100 Series - Page 625

Configuring the Egress Port Rate Limiting Introduction
6-65
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
DESTROY EGRESSLIMITER
Syntax
DESTROY EGRESSLIMITER={limitername-list|ALL}
Description Attempts to remove every specified EGRESSLIMITER from the system, and returns an
error message for any that cannot be destroyed. This command is allowed only if no
ports or interfaces are currently associated with the EGRESSLIMITER(s). Use
DELETE
EGRESSLIMITER INTERFACE
to delete EGRESSLIMITER associations to ports/interfaces.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example DESTROY EGRESSLIMITER=ALL
Option Description Default Value
EGRESSLIM-
ITER
The name of the EGRESSLIMITER that has already been
created.