Configuring Port Authentication Introduction
6-101
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
Set interim update to ON, and change accounting period to 60. (Refer to SET RADIUS AUTHMODE (SEC).)
5
SET RADIUS ACCOUNTINGPERIOD=60 INTERIMUPDATE=ON
Display RADIUS configuration.
6
SHOW RADIUS
--- RADIUS --------------------------------------------------------------------
Auth Mode............................. Login
Interim-Update........................ ON
Accounting Period..................... 60
RADIUS Servers ------------------------------------------------------------
Hostname/IP Auth Acct Time
Address Status Pri Port Port Retries out Function Type
---------------- -------- --- ----- ----- ------- ----- ---------------- -----
192.168.10.205 Enabled 1 1812 1813 2 5 AUTHENTICATION, LOGIN
ACCOUNTING ,DOT1X
192.168.10.206 Enabled 2 1812 1813 2 5 AUTHENTICATION, LOGIN
ACCOUNTING ,DOT1X
192.168.10.207 Enabled 3 1812 1813 3 5 AUTHENTICATION, LOGIN
ACCOUNTING ,DOT1X
Enable 802.1X for the SBx3112.
7
ENABLE DOT1X
Enable 802.1X for the specific interfaces.
8
ENABLE DOT1X INTERFACE=6.22-6.23
Start accounting using the parameter STARTSTOP, so a START accounting message is sent at the beginning of a session
and a STOP accounting message is sent at the end of a session.
Note: Ensure the RADIUS server(s) also have the accounting option enabled. Refer to Step 4.
9
SET DOT1X ACCOUNTING=STARTSTOP
SHOW DOT1X
--- Port Authentication Information ---
802.1X
------
802.1X Port-Based Authentication...... Enabled
RADIUS Accounting...................... Start-Stop
TABLE 6-19 Configuration procedure for Port Authentication
Step Command Description
To Next Page
Loading...
