Configuring Port Authentication Introduction
6-109
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
CLEAR DOT1X INTERFACE
Syntax
CLEAR DOT1X INTERFACE={ type:id-range | id-range | ifname-list |
ALL } [ SUPPLICANT={ macaddress-list | ALL } ]
Description This command initializes the 802.1X status of supplicants on the specified interface, and
attempts reauthentication. Use this command to un-authorize an interface, and attempt
reauthentication on the specified interface.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
CLEAR DOT1X INTERFACE=ETH:6.22
Option Description Default Value
INTERFACE The ethernet interfaces over which the 802.1X status
will be initialized.
N/A
SUPPLI-
CANT
Specifies a supplicant's MAC address or ALL supplicants. ALL
To Next Page
Loading...
