Configuring Port Authentication Introduction
6-113
Software Reference for SwitchBlade x3100 Series Switches (Access and Security)
DISABLE DOT1X INTERFACE
Syntax
DISABLE DOT1X INTERFACE={ type:id-range | id-range | ifname-list |
ALL }
Description This command disables 802.1X Port Authentication on the interface specified. Note that
once an interface is enabled its settings are maintained, even if all interfaces are disabled
system-wide using
DISABLE DOT1X.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
DISABLE DOT1X INTERFACE=6.22-6.23
Option Description Default Value
INTERFACE The ethernet interfaces over which the 802.1X feature
will be disabled.
N/A
To Next Page
Loading...
