Allied Telesis SwitchBlade x3100 Series User Manual

Introduction Configuring DHCP Relay
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
7-24
ADD DHCPRELAY SERVER
Syntax
ADD DHCPRELAY={ dhcpname-list | MAIN | ALL } SERVER=ipaddress-list
Description The ADD DHCPRELAY SERVER command is used to configure up to 10 DHCP server
IP addresses with the relay agent. The user can specify a single IP address or the comma
separated list of IP addresses. For DHCP Relay, the relay agent will forward all DHCP
broadcast messages to each configured IP address. For messages containing Server Iden-
tifier Option (54), the message will be unicast to the server IP address in the message.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
ADD DHCPRELAY=X3112 SERVER=10.52.65.39
Option Description Default Value
DHCPRELAY The name of the DHCP instance
dhcpname-list - list of specific DHCP instances
MAIN - the default DHCP instance
ALL - all DHCP instances
N/A
SERVER ipaddress-list - the list of IP addresses being sent to the
DCHP server by the relay agent separated by a comma
N/A

Allied Telesis SwitchBlade x3100 Series Specifications

General

Brand	Allied Telesis
Model	SwitchBlade x3100 Series
Category	Switch
Language	English