Configuring an SNMP Community Introduction
7-59
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
DESTROY SNMP COMMUNITY (SEC)
Syntax
DESTROY SNMP COMMUNITY=name
Description The DESTROY SNMP COMMINUTY command destroys an existing SNMP community
from the system and all of the trap hosts and managers that are associated with it. The
COMMUNITY parameter specifies the SNMP community. The community must exist in
order to destroy it.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example DESTROY SNMP COMMUNITY=system_test
Option Description Default Value
COMMU-
NITY
name - the name of the SNMP community; a case-sensi-
tive alphanumeric string of 1 to 15 characters.
To Next Page
Loading...
