Introduction Configuring an SNMP Community
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
7-68
SHOW SNMP COMMUNITY (SEC)
Syntax
SHOW SNMP COMMUNITY [ ={ name-list | ALL } ]
Description The SHOW SNMP COMMUNITY command displays information about a single SNMP
community. The COMMUNITY parameter specifies the name of the community. A com-
munity with the specified name must already exist in the device. The following is example
output from the SHOW SNMP COMMUNITY command:
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example SHOW SNMP COMMUNITY
SNMP community information:
Name .......................... public
Access ........................ read-only
Status ........................ Enabled
Traps ......................... Enabled
Open access ................... Yes
Manager ....................... 192.168.1.1
Manager ....................... 192.168.5.3
Trap host ..................... 192.168.1.1
Trap host ..................... 192.168.6.23 v2c
Traphost ...................... 192.168.6.24
Option Description Default Value
COMMU-
NITY
name-list - the name of the SNMP community; a case-
sensitive alphanumeric string of 1 to 15 characters.
ALL - all SNMP communities on the system
To Next Page
Loading...
Need help?
General
