Allied Telesis SwitchBlade x3100 Series - Page 805

Configuring an SNMP Community Introduction
7-67
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
SHOW SNMP (SEC)
Syntax
SHOW SNMP
Description The SHOW SNMP command displays information about the device's SNMP agent. SNMP
configuration and SNMP counters are displayed.
Options N/A
Example
>SHOW SNMP
------------------------------------------------------------------------
SNMP Configuration:
------------------------------
Status........................ Enabled
Authentication Failure Traps.. Disabled
Community..................... system_test
Access...................... READ-ONLY
Status...................... Enabled
Traps....................... Disabled
Open Access................. On
SNMP Counters:
------------------------------
inPkts........................ 116 outPkts....................... 2
inBadVersions................. 0 outTooBigs.................... 0
inBadCommunityNames........... 116 outNoSuchNames................ 0
inBadCommunityUses............ 0 outBadValues.................. 0
inASNParseErrs................ 0 outGenErrs.................... 0
inTooBigs..................... 0 outGetRequests................ 0
inNoSuchNames................. 0 outGetNexts................... 0
inBadValues................... 0 outSetRequests................ 0
inReadOnlys................... 0 outGetResponses............... 0
inGenErrs..................... 0 outTraps...................... 2
inTotalReqVars................ 0
inTotalSetVars................ 0
inGetRequests................. 0
inGetNexts.................... 0
inSetRequests................. 0
inGetResponses................ 0
inTraps....................... 0
------------------------------------------------------------------------