Configuring RMON Ethernet Statistics Introduction
7-103
Software Reference for SwitchBlade x3100 Series Switches (Network Management)
SET INTERFACE COUNTER
Syntax
SET INTERFACE={ type: | type:id-range | id-range | ifname-list |
ALL } COUNTER { ON | OFF }
Description The SET INTERFACE COUNTER command enables or disables network monitoring on
an interface or interfaces. The act of enabling monitoring does not affect the administra-
tive state of the interface. This command only affects the state of network monitoring.
Note: If SET INTERFACE COUNTER is used to enable network monitoring while the
interface is disabled, no monitoring will occur until the interface is enabled with the
ENABLE INTERFACE command.
Options The following table gives the range of values for each option that can be specified with
this command and a default value (if applicable).
Example
SET INTERFACE=10.0 COUNTER=ON
Option Description Default Value
INTERFACE A logical representation of one or more physical ports;
the INTERFACE for which RMON data is enabled
type:id-range - the type of available ports, such as
ETH:7.0 or a range (ETH:8.0-8.9)
id-range - used with type (type:id) to query the physical
ports; the numerical identifier of the interface
ifname-list - list of interface names, if not numerical
ALL - used to specify the same historical data collection
parameters on all applicable interfaces in the system
COUNTER The number of times a counter increments on the inter-
face for a statistic.
ON - enables counter
OFF - disables counter
To Next Page
Loading...
Need help?
General
