BD Alaris - Symbols Glossary

Chapter 1—Introduction
6BD Alaris
TM
System with Guardrails
TM
Suite MX User Manual
Symbols Glossary
The following table shows the symbols and the applicable standards used in this user manual.
Symbol
(Graphical
Image)
Definition Symbol Title Symbol
Location
Ref. No. Standard
The Infusion Alarm Silence symbol
indicates that infusion alarms have
been acknowledged and silenced.
Press the CANCEL SILENCE soft
key to reactivate a previously
silenced alarm audio. If the alarm
condition has not been resolved, the
alarm audio will resume.
Bell Canceled
Acknowledge
(Alarm Cancel)
PCU Interface Ref 5576-1 IEC 60417-1
Graphical Symbols
for
use on equipment. Part 1:
Overview and
Application
The infusion alarm silence symbol
indicates the module that has been
acknowledged and silenced.
Bell Cancel
(Alarm Cancel)
PCU Interface Ref 5576-1 IEC 60417-1
Graphical Symbols for
use on equipment. Part 1:
Overview and
Application
Type CF defibrillation-proof patient
applied part.
Defibrillation-
proof Type CF
Applied Part.
PCU, pump
module,
syringe
module, PCA
module
device labels
Ref 5336 IEC 60417-1
Graphical Symbols for
use on equipment. Part 1:
Overview and
Application
Products bearing this mark have been
tested and certified in accordance
with applicable U.S. and Canadian
electrical safety and performance
standards.
Canadian and
U.S.
Certification
Mark
PCU and all
modules,
(except SpO
2
module), and
device labels
NA
Do not dispose of electronic products
in the general waste stream.
Waste stream
disposal status
PCU and all
modules,
device labels
(except SpO
2
module)
Directive 2002/96EC
(WEEE)
Indicates the need for the user to
consult the instructions for use for
important cautionary information
such as warnings and precautions
that cannot, for a variety of reasons,
be presented on the medical device
itself.
Follow
instructions for
use
PCU, EtCO
2
module
device labels
Ref. 10: IEC 60601-1,
Table D.2, Medical
electrical equipment —
Part 1: General
requirements for basic
safety and essential
performance.
Alternating Current: Indicates device
should be attached to alternating
current source, 50/60 Hz only.
Alternating
Current
PCU device
label
Ref 5032 IEC 60417-1
Graphical Symbols for
use on equipment. Part 1:
Overview and
Application
C
US