Chapter 5—Alaris™ SpO
2
Module Models 8210 and 8220
258 BD Alaris
TM
System with Guardrails
TM
Suite MX User Manual
Getting Started
Introduction
This section applies to SpO
2
modules upgraded with v9.33 software.
This section of the user manual provides SpO
2
module (models 8210 and 8220) instructions and
information. It is used in conjunction with:
• Nellcor™ and Masimo SET™ cable and sensor instructi
ons
• PCU chapter of this manual (see Getting Started on page 16)
•
Nellcor™ Monitor Sensor Compatibility Card -
Alaris™ SpO
2
module model 8210
• Masimo™ Monitor Sensor Compatibility Card - Alaris™ SpO
2
module model 8220
• SpO
2
module Technical Service Manual
• System maintenance software (and its instructions) for system che
ck-in, maintenance, and
configurations for connecting the PCUs to the wireless network
The SpO
2
modules are indicated for continuous, noninvasive monitoring of functional oxygen saturation of
arterial hemoglobin (SpO
2
) and pulse rate measured by a SpO
2
sensor. The SpO
2
modules and accessories
are indicated for use with adult, pediatric, and neonatal patients, and for patients who are well or poorly
perfused in hospitals and hospital type facilities. The model 8220 SpO
2
module is also indicated for use
during motion and no motion conditions. Clinical functions will only be provided to one SpO
2
module at a
time.
Please consult the facility's best practices guidelines on the preferred
alarm settings for the monitoring of
patients that are not continuously attended by a clinician.
The majority of user interface programming
is identical for both SpO
2
modules. If a procedure/information
applies to a specific module, the following identifiers indicate the applicable model.
Model 8210:
(8210)
Model 8220:
(8220)
Cables and Sensors: See Sensors and Cables on page 273 for information.
Alarms, and Messages: See Appen
dix A Troubleshooting and Maintenance on page 324 for module-
specific alarms and messages.
Contraindications: T
he
SpO
2
modules are contraindicated for use as apnea monitors.
Electromagnetic Environment: See Appe
ndix A Regulations and Standards on page 354 and
Compliance on page 35
4 for this information.
Read all instructions for the SpO
2
module and PCU, before using the system.
To Next Page
Loading...
